Control

Send Method Sends method, that is displayed in the Single Analysis dialog on the Method row, to controlled devices.
Shut Down Function is individual for each device. Detailed description is in a separate manuals for Control modules.
LC Control
  • Stop Flow : Function is individual for each device. Detailed description is in a separate manuals for Control modules.
  • Set Flow… : Command for flushing/purging the pump outside a run.
  • Resume Idle : Resumes back to IDLE state after flushing/purging the pump using the Purge command.
  • Hold : Pauses the execution of the Gradient Table at the actual flow and mobile phase composition. The same flow and composition will be maintained until the Resume button is pressed.
  • Resume : Resumes the execution of the Gradient Table after the Hold button has been pressed.
  • Modify Gradient… : Opens the LC Control Manual Flow dialog allowing to set custom flow and mobile phase composition, disregarding the Gradient Table set in the method.
  • Note:

    Availability of Resume / Hold and Modify Gradient commands depend on the capabilities of pumps used in the gradient. The commands are only available while an analysis is running.